|Table of Contents|

[1] Xiao Gang, Chi Yong, Ni Mingjiang, Cen Kefa, et al. Study on fluidized-bed pyrolysis of waste paper [J]. Journal of Southeast University (English Edition), 2007, 23 (2): 285-288. [doi:10.3969/j.issn.1003-7985.2007.02.026]
Copy

Study on fluidized-bed pyrolysis of waste paper()
废纸流化床热解特性试验研究
Share:

Journal of Southeast University (English Edition)[ISSN:1003-7985/CN:32-1325/N]

Volumn:
23
Issue:
2007 2
Page:
285-288
Research Field:
Energy and Power Engineering
Publishing date:
2007-06-30

Info

Title:
Study on fluidized-bed pyrolysis of waste paper
废纸流化床热解特性试验研究
Author(s):
Xiao Gang1 Chi Yong2 Ni Mingjiang2 Cen Kefa2 Xiao Rui1 Huang Yaji1(1Key Laboratory of Clean Coal Power Generation and Combustion Technology of Ministry of Education Southea
2State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, China
肖刚1 池涌2 倪明江2 岑可法2 肖睿1 黄亚继1
1东南大学洁净煤发电与燃烧技术教育部重点实验室, 南京 210096; 2浙江大学能源清洁利用国家重点实验室, 杭州 310027
Keywords:
waste paper fluidized bed pyrolysis syngas bio-oil
废纸 流化床 热解 合成气 生物油
PACS:
TK229
DOI:
10.3969/j.issn.1003-7985.2007.02.026
Abstract:
A lab-scale fluidized bed is setup and pyrolysis experiments are carried out.When temperature ranges from 400 to 700 ℃, the yields of solid residue, bio-oil and syngas range from 36% to 18%, 19% to 30% and 9% to 42%, respectively, and the mass balance of pyrolysis ranges from 80% to 95%.At 400 to 700 ℃, the characteristics of bio-oil are similar and the heat value is about 10 MJ/kg.When the temperature is over 600 ℃, the yield of syngas increases approximately twice as much as that at 500 ℃.The yields of CO2 and CO increase from 70 to 230 L/kg and 50 to 106 L/kg, respectively, while the yield of syngas only increases about 5% when the temperature increases from 600 to 700 ℃.The results indicate that the pyrolysis mechanism of waste paper is similar from 400 to 700 ℃, while the yield of syngas can be affected by secondary pyrolysis of bio-oil.
在自行设计的流化床实验台上进行废纸热解实验研究.当热解温度从400 ℃升高到700 ℃时, 固体残渣产率从36%降低到18%, 而热解油、热解气产率分别从19%增加到30%和9%增加到42%.实验的质量平衡达到80%~95%.各温度下, 液体产物特性相似, 热值都为10 MJ/kg左右, 说明在此温度范围内, 热解反应机理相似.当反应温度从500 ℃提高到600 ℃以上时, 热解气产量几乎提高一倍, 其中CO2与CO产量分别从大约70 L/kg提高到230 L/kg和50 L/kg提高到106 L/kg;而温度从600 ℃提高到700 ℃时, 热解气产量仅提高5%.研究表明, 热解油的二次裂解会影响热解气产量.

References:

[1] Patumsawad S, Cliffe K R.Experimental study on fluidized bed combustion of high moisture municipal solid waste[J].Energy Conversion and Management, 2002, 43(17):2329-2340.
[2] Thipse S S, Sheng C, Booty M R, et al.Chemical makeup and physical characterization of a synthetic fuel and methods of heat content evaluation for studies on MSW incineration[J].Fuel, 2002, 81(2):211-217.
[3] Xiao Gang, Ni Mingjiang, Chi Yong, et al.Research on low emission MSW gasification and melting system[J].Environmental Science, 2006, 27(2):381-385.
[4] Wu C H, Chang C Y, Tseng C H.Pyrolysis products of uncoated printing and writing paper of MSW[J].Fuel, 2002, 81(6):719-725.
[5] Gronli M, Antal M J, Varhegyi G.A round-robin study of cellulose pyrolysis kinetics by thermagravimetry[J].Ind Eng Chem Res, 1999, 38(6):2238-2244.
[6] David C, Salvador S, Dirion J L, et al.Determination of a reaction scheme for carboard thermal degradation using thermal gravimetric analysis[J].Journal of Analytical and Applied Pyrolysis, 2003, 67(2):307-323.
[7] Deng Na, Zhang Yufeng, Xie Hui, et al.Model gasification stage in pyrolysis and gasification treatment process of municipal solid waste[J].Journal of Tianjin University, 2006, 39(4):463-468.(in Chinese)
[8] Cen Kefa, Chi Yong, Li Aimin, et al.Pyrolysis of municipal solid waste in rotary kiln:studies on characteristics of pyrolytic tar[J].Journal of Combustion Science and Technology, 2000, 6(3):195-199.(in Chinese)
[9] Zhang Yufeng, Deng Na, Zhang Shuting, et al.Pyrolysis on screen residue of municipal household waste[J].Journal of Tianjin University, 2005, 38(6):556-560.(in Chinese)
[10] Diebold J P.A unified, global model for the pyrolysis of cellulose[J].Biomass and Bioenergy, 1994, 7(1):69-74.
[11] Jin Baosheng, Zhou Hongchang, Zhong Zhaoping, et al.Preliminary study on PAHs emission from coal gasification [J].Journal of Southeast University:Natural Science Edition, 2005, 35(1):1-5.(in Chinese)
[12] Wooten J B, Seenman J I, Hajaligol M R.Observation and characterization of cellulose pyrolysis intermediates by 13C CPMAS NMR: a new mechanistic model[J].Energy and Fuels, 2004, 18(1):1-15.
[13] Tan Hong.Mechanism study of biomass pyrolysis[D].Hangzhou:State Key Laboratory of Clean Energy Utilization of Zhejiang University, 2005.(in Chinese)
[14] Raveendran K, Ganesh A, Khilar K C.Influence of mineral matter on biomass pyrolysis characteristics[J].Fuel, 1995, 74(12):1812-1822.
[15] Zhang Jun, Fan Zhilin, Lin Xiaofen, et al.Online measurement of products during fast pyrolysis of biomass[J].Journal of Southeast University:Natural Science Edition, 2005, 35(1):16-19.(in Chinese)
[16] Chen G, Andries J, Luo Z, et al.Biomass pyrolysis/gasification for product gas production: the overall investigation of parametric effects [J].Energy Conversion and Management, 2003, 44(11):1875-1884.

Memo

Memo:
Biography: Xiao Gang(1979—), male, doctor, lecturer, xiaogangtianmen@seu.edu.cn.
Last Update: 2007-06-20